Tools and Materials Needed

Before you begin, gather the necessary tools and materials:

Replacement screen (compatible with iPhone 12)

Pentalobe screwdriver (P2)

Phillips screwdriver (PH000)

Tri-point Y000 screwdriver

Plastic opening tool

Suction cup

Tweezers

Adhesive strips

Heat gun or hairdryer (optional)

Step-by-Step Guide

Power Off Your iPhone 12

Before starting any repair, make sure your device is powered off. iphone 12 replacement screen Hold down the power button until the "slide to power off" option appears, then slide to turn off your iPhone.

Remove the Pentalobe Screws

Using the Pentalobe screwdriver, remove the two screws located on either side of the lightning port at the bottom of the device. Keep these screws in a safe place as they are small and easy to lose.

Create a Gap

To separate the display from the back panel, you need to create a small gap. Place the suction cup near the bottom edge of the screen, just above the home button area. Gently pull up on the suction cup to create a gap between the screen and the frame. If necessary, use a heat gun or hairdryer to soften the adhesive around the edges.

Open the iPhone

Once you have a gap, insert the plastic opening tool into the gap and carefully slide it around the edges to release the adhesive. Be patient and gentle to avoid damaging any components inside the phone. Once the adhesive is loosened, you can lift the screen to open the iPhone.

Disconnect the Battery

Before you proceed with screen replacement, disconnect the battery to prevent any electrical damage. Locate the battery connector shield and use the Phillips screwdriver to remove the screws. Carefully lift the shield and disconnect the battery connector using the plastic opening tool.

Remove the Display Assembly

Next, you need to remove the display assembly. Locate and remove the screws securing the display connectors using the tri-point Y000 screwdriver. Carefully disconnect the display cables and set the old screen aside.

Install the New Screen

Take your new screen and connect the display cables to the corresponding connectors on the iPhone. Ensure each connection is secure before proceeding. Once the new screen is connected, reattach the display connector shield and secure it with the screws.

Reconnect the Battery

Reconnect the battery connector and reattach the battery connector shield. Secure it with the screws you removed earlier.

Seal the iPhone

Carefully align the new screen with the frame of the iPhone and press it into place. Apply gentle pressure around the edges to ensure the adhesive sticks. iphone xs max repair If your replacement screen did not come with adhesive, you may need to apply new adhesive strips.

Replace the Pentalobe Screws

Finally, replace the two Pentalobe screws on either side of the lightning port. Once the screws are in place, power on your iPhone to ensure the new screen is working correctly.

Final Thoughts

Replacing the screen on your iPhone 12 can seem daunting, but with the right tools and a detailed guide, it's a manageable task. By following these steps, you can save money and extend the life of your device. If at any point you feel uncomfortable or unsure, seek professional assistance to avoid further damage to your phone.